Product Details

• Amazon Sales Rank: #242289 in Home Improvement
• Brand: DELTA
• Model: 50-354
• Dimensions: 3.00" h x 15.50" w x 16.00" l,

From the Manufacturer
Delta 50-354 Dust Connector for Series 2000 Contractors Saws

Customer Reviews

Most helpful customer reviews

11 of 11 people found the following review helpful.
Not a perfect fit
By A Customer
The picture (here) is not complete. There are 2 metal flanges that get connected to the bottom of the saw using the existing screws for the stand, then the heavy duty plastic dust connector is held to the flanges by sheet metal screws. Installing it is pretty straight forward, except that there is a gap about 3/8" between both sides of the dust collector and the saw case, allowing some saw dust to fall to the floor.

5 of 5 people found the following review helpful.
Be careful/50/354
By Michael C. Klinnert
I recently purchased a Delta 36-680 table saw with the recommended 50-354 dust collection system for the bottom of the saw. Well come to find out it did not come close to fiiting ,because it was not designed for this saw----it was designed for an older model. I learned this info. from a service center and a tech. at Delta. Apparently they had several hundred of the 50-354 left over,and chose to continue saying that it was an appropriate accessory in the catalog. Please be advised it's not wide enough (plastic part and the metal brackets holes do not match up.I bought Delta because of reputataion. Now I'm wondering,and am hoping the saw is better than the accessories. By the way,neither the tech. guy or the guy at the service ctr. we're surprised.They heard it was an economic decision from higher up.

4 of 4 people found the following review helpful.
Disappointing
By A Customer
Bought this attachment for my Delta contractors saw and was disappointed. It is farely easy to install but once it is in place it leaves a crack about one half inch wide along each side running from the front to back. There are two heavy steel spacers that go on each side to fill in the void but they are not wide enough for some reason and the crack is just wide enough for saw dust to fall through to the floor. This crack serves no purpose that I can think of and I plan to cover it with duct tape or something to see if it will solve the problem.